|
|
Ventus 2C
Semi scale all fiberglass high performances glider.
 Built to offer the best performances in flight, and for this reason not 100% to scale.
The wing is all moulded in fiberglass and has a very special spar made with ply, carbon rowing, carbon and glass tissue, uses a special modified Eppler profile to offer good performances in a very broad speed ranges.
The wing is supplied with ready made holes for the 6 needed wing servos (2 airbrakes, 2 ailerons and 2 flaps), and with the airbrakes ready fitted.
Is it possible to use 2 more servos for the outer aileron parts if you like.
The fuselage is made in carbon reinforced fiberglass and is strong enough to resist the flight (and landing) stress, and it is possible to fit a tow release device and the retractable landing gear (not supplied).
Elevator and rudder are all moulded too. The model is supplied with all the hardware to complete the model, including airbrakes.
The model requires 8 servos, 2 (or 4) ailerons, 2 flaps, 2 airbrakes, rudder and elevator; tow release and retractable gear are optionals.
On request we can supply the Ventus 2C ready to fly with servos installed and all the works done; just install your receiver and you will be able to fly.
The pictures on the left shows a Ventus 2C completed by a Master Builder. The Xmodel kit includes the white cockpit only without instruments panel, seat and pilot puppy.
Wingspan: 4,50 m.
Lenght: 1,65 m.
Wing area: 64 dmq.
Profile: Eppler mod
Empty weight: 3,6 kg.
Flying weight: from 5,5 kg.
Ailerons, flaps, rudder, elevator, airbrakes
|
|
